I got a basic question of efi mm command.
#Startx on boot windows
6249 or later on Windows 7/8 operating systems will be dual boot.
#Startx on boot for windows 10
RUFUS is the most popular choice software for Windows 10 bootable USB tool. The command below succeeds on the monitored host Command: /opt/lsi/bin/sas2ircu Output contains: SAS2IRCU: No command specified (regex) The command below succeeds on the monitored hostExecute sas2ircu. The LSI sas2ircu Managed Raid Controllers connector will be automatically activated, and its status will be reported as OK if all the below criteria are met.
If there are no errors it will: save a file (at /root/.sas2ircu/drives) with a mapping of device names to enclosure slots Connector Activation Criteria. It will check the selected pool (via zpool status). you can use sas2ircu list to identify your controller number. There aren't any options for replacing a disk in an array, and the server in question has a very minimal remote management console which doesn't even mention storage at all…It does make a few assumptions, i think the main one is that it is attached to controller 0.
#Startx on boot how to
The sas2ircu command-line tool is quite "light" on features, and it wasn't at all obvious to me how to get a replacement disk to re-add to an array. To review, open the file in an editor that reveals hidden Unicode characters. As sas2ircu and sas2ircu-status anyway are of no use to me, the solution was to simply purge the sas2ircu* packages and hey presto, log messages stopped immediately.This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. The service you configured should auto-start as the server boots up.Apparently sas2ircu-status was trying to request some information from the controller to which it responded by putting broccoli in his ears. Go ahead and do a test reboot of your server. Systemctl start rvice Test your service with a reboot! Tell systemd to enable your custom system unit:Ĭonfirm that your test service was created successfully: WantedBy=default.target Configure your service to automatically start on boot Make sure you reference the script that you created above and that you save the system unit with a ".service" extension.ĭescription=A description for your custom service goes hereĮxecStart=/bin/bash /usr/sbin/testscript.sh This system unit is how systemd will know to run the test script at system boot.Ĭreate the following file in /etc/systemd/system/rvice. We will now create a system unit that references the above test script. You may follow this guide to help you SSH into your SkySilk VPSĬreate the sample script or program that we want to automatically start on bootĬreate the following script in /usr/sbin/testscript.sh using your favorite text editor (like nano):Ĭhmod +x /usr/sbin/testscript.sh Create a system unit (also known as a service) Finally, we will tell systemd, to automatically run our script (service unit) on system startup. Next, we will create a system unit that references our sample script. We will be utilizing systemd for this task. How to start a program on Linux automatically on boot How to ensure that those services always auto-start, even after an unplanned reboot. This guide will be helpful to those that run critical services on their Linux machines. If you have a Linux server and have a need to configure a service or program to automatically start on boot, this guide will demonstrate how to do so. Configure your service to automatically start on boot.Create a system unit (also known as a service).Create the sample script or program that we want to automatically start on boot.How to start a program on Linux automatically on boot.